Support Center

Upgrading the Air Sync's Firmware

Last Updated: Nov 03, 2015 03:17PM MST

Step 1: Open Your Air Sync's Web UI and Head to Settings.

  • Make sure your Air Sync is powered on and you are connected to the Air Sync's Wifi network.
  • Open in your browser to access the Air Sync's web-based UI.
  • In the top right hand side of the web UI select Settings.

  • Type in Administrator Password, default password is ‘0000’ (Note: You can change this later for security).

Step 2: Setup Your Air Sync to Operate as a WiFi Bridge

  • On the left-hand panel in the web UI select ‘Router/Bridge Mode’ and turn "Bridge Mode Status" to ON.

  • The system will then scan for open WiFi networks.
  • Select your personal network from the list located at below the On/Off switches.

  • If your WiFi access point requires a password you will be prompted to enter your password in order to be able to connect. 

Step 3: Check for new firmware.

  • Click on Firmware Upgrade on the left menu.

  • Select button "Check for new version".
  • If a new firmware version is available, a window as shown below, will appear.


Step 4: Upgrade your Air Sync's Firmware

  • Click on Firmware Upgrade on the left menu to begin the upgrade process.

  • Once the Firmware is upgraded, the system will command you to ‘Reboot’ or restart the device. Please wait 40 seconds, and then hit ‘Refresh’.

  • Be patient - the device will reboot when complete and may power off.  
  • If your Air Sync powers off - no problem - just reboot it, reconnect, and re-enter your web UI ( to confirm the upgrade is complete!


Contact Us
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found